24
Rascal Veo, Veo X & Veo Sport Scooter
Engineer’s Checklist for the Rascal Veo range of scooters
Important Note for the Engineer
Enquire if the customer is satisfied with the product. Please report all points good or bad directly to:
Electric Mobility 01460 258100 If you have any comments please include them.
Obtain all comments from the customer on the condition and serviceability of the scooter and then complete
an Initial diagnostic road test. Record all defects to be corrected. Now check, test and complete the following:
• Wheel bearings wear and lubricate
• Wheel alignment and tracking
• Speed dial works correctly
• Wear or damage to tyres or wheels
• Bodywork fixtures for damage, or cracking
• Throttle play and adjustment
• Battery packs and internal electrical
connections for condition and corrosion.
• Check all cables for damage, abrasion, corrosion
and that screening is intact. Replace as necessary
• Steering bearing (adjust as required)
• Check suspension components on
Veo Sport model.
• Tiller adjustment - functioning, wear and damage
• All assembly spigots and hooks for wear or damage.
• Seat mounting for wear or damage
• Revolving seat mechanism locates correctly
and spring lever engages. Lubricate as necessary.
• Handlebar/tiller alignment
• Check motor and gearbox for unusual noise or
vibration; investigate as necessary.
• Electromagnetic brake operation – does the
scooter slow when the hand control is released?
Does the brake engage when the scooter is
pushed when in freewheel?
• Freewheel operation
• Frame for damage or cracks
• General check for corrosion, repair or protect as
necessary
• All operational controls work correctly
• Battery condition and charger operation
• Tighten all nuts & bolts
• Correct all defects found and determine if the vehicle
is roadworthy.
• Final road test
• Clean the vehicle.
• Customer road test
To Next Page
Loading...
