7
INSTALLATION INSTRUCTIONS
Please Note - Electrical Connection
The oven is fitted with a plug and must only be connected to a properly
installed earthed socket. The socket must only be installed and the
connecting cable must only be replaced by a qualified electrician, in
accordance with the appropriate regulations. If the plug is no longer
accessible following installation, an all-pole isolating switch must be
present on the installation side with a contact gap of at least 3mm.
The fitted cabinet must not have a back wall behind the appliance.
A gap must be maintained between the wall and the base of the unit above.
Specific gap size should be referenced by the diagrams.
Minimum installation height: 85cm
Do not cover ventilation slots and suction holes.
Note:
Do not trap or bend the power cable
Screws
Bracket
To Next Page
Loading...
