7
SHIFT 1 & 2 Modes – Both SHIFT mode channels are identical. In either
mode, VALUE selects the amount the input signal is transposed. The
VALUE knob scrolls through the available SHIFT mode values, which
covers a total range of +/- three octaves.
SHIFT MODE VALUES
Note: For negative SHIFT values the signal is transposed down from root, -1OC
is an octave below and a detune value of -38c, for example, is 38 cents below the
root.
Selecting detune
(D.) in a SHIFT mode detunes the input signal by an
amount of +/- 99 cents. The detune sub-menu adjusts the amount in one-
cent increments, ranging from 1 to 99.
To set the detune value:
1. Select desired SHIFT mode.
2. Use VALUE to scroll to detune (D.).
3. Press VALUE to enter the detune sub-menu.
4. Turn VALUE to adjust detune in increments of one cent in either
plus or minus amounts.
5. Once the desired detune value is found, exit the detune sub-menu
by pressing any mode button.
Detune can be added to any SHIFT 2 interval by enabling the S2D2 sub-
menu within X-MOD. The detune setting in SHIFT 2’s
D.
menu at the time
that
S2D2.
is enabled will be added to SHIFT 2’s interval setting. For
example, if SHIFT 2 is set to 1OCT and SHIFT 2’s detune is set to +16c,
when S2D2 is ON, SHIFT 2 transposes by a total amount of 1OCT+16c.
This is useful for creating lush detuning sounds between SHIFT channels
1 and 2 when they are set to the same SHIFT mode value.
To Next Page
Loading...
