Electro-Optics Technology, Inc.
3340 Parkland Ct. Traverse City, MI 49686 USA
(231)935-4044 ׀ (800)697-6782 ׀ sales@eotech.com ׀ www.eotech.com
Page 4 of 9
5. You can terminate the detector in 1MΩ input of an oscilloscope to obtain a higher output voltage
signal but this will decrease the detector’s bandwidth by a factor of 5x10
-5
.
C. Increasing the power incident on the detector does not result in a higher voltage signal on the
oscilloscope:
1. The detector is probably saturated. You should lower the power incident on the detector to a
level below the saturation point.
IV. Drawings: Non-amplified Photodetectors
A. ET-2030 Dimensions:
B. ET-2040, ET-2070 Dimensions:
To Next Page
Loading...