Electro-Voice SxA180 - Product Overview; Description and System Features

ELECTRO-VOICE
®
Owner’s Manual
Description
Electro-Voice
®
S
x
A series powered loudspeakers are fully integrated audio systems with
carefully matched electronics and transducers. These products make it easy to setup a high-
quality sound system quickly with a minimum of cables and external electronics. They retain
typical EV ruggedness, reliability and impeccable sound quality.
System Features – S
x
AA
AA
A Two-Way Systems
·
Integrated mixer/crossover/amplifiers/speaker system with separate mic and line inputs,
EQ and line-level outputs.
·
Two built-in power amplifiers, one for low frequencies and one for high frequencies. The
amplifiers also contain electronic crossover circuitry and CD horn compensation optimized
for the speaker components a well as a limiter circuit that prevents either amplifier from
clipping while preserving the sonic quality.
·
The low-frequency power amplifier delivers 150 watts continuous average power and 350
watts dynamic power (IHF A). Dynamic output power is important because it determines
the transient capability of the system.
·
The high-frequency power amplifier delivers 50 watts continuous average power and 80
watts dynamic power (IHF A). This provides more than 3 dB of headroom over the
continuous current capabilities of the high-frequency driver.
·
The line input utilizes Neutrik “combo” connectors, which will accept either ¼-inch or 3-
pin XLR-type connectors.
·
The mic input is balanced, low-impedance 3-pin XLR-type
·
The separate line output is 3-pin XLR-type balanced, low-impedance output that can be
used with long cable runs.
·
Two-band EQ provides tonal shaping to compensate for program material, room acoustics
and personal taste.
·
S
x
A two-way systems are perfect for use as powered floor monitors.
System Features - S
x
AA
AA
A 180 Powered Woofer
·
Integrated power amplifier, electronic crossover and low-frequency speaker designed to
add extended bass to S
x
A systems
·
Class D amplifier with 300 watts continuous average power, 650 watts dynamic power
(IHF-A). A built-in limiter prevents serious amplifier clipping and minimizes the potential
for speaker damage.
·
18-inch EV DL woofer with 2.5-inch voice coil for reliable low-frequency output to 38 Hz.
·
Line input with balanced 3-pin XLR-type connector
·
Crossover with continuously variable low-pass frequency from 80 Hz to 120 Hz
·
Filtered high-pass output and paralleled full-range output on balanced 3-pin XLR-
type connectors.
·
Storage compartment with detachable dolly board and casters for easy transportation. The
dolly board covers a storage compartment that holds a 34-inch pole and has ample space
for cables, etc.
·
Comes with 34-inch pole for elevating any EV speaker system with 1 3/8-inch
stand mount.
ELECTRO-VOICE
®
Owner’s Manual 4