ELECTROCOMPANIET ECT 3 - Page 10

10
1.8 Connecting the remote control
This is an example showing how to include the preamplifier EC4.9 to
the ECT 3:
1. Turn off the EC4.9
2. Then press and hold the Navigator down button, and switch on the
EC4.9 while still pressing down the down button.
3. The display on EC4.9 will show the message "searching for remote"
after power on.
4. Now, at the same time press the Connect
option in the Setup ECT 3 Menu.
5. On the EC4.9, the display will change to "Remote found with serial
number - product serial number”
6. Finally turn off the EC 4.9, wait 5 seconds and power up again.
Now the units are connected.
Searching...
.................
EC 4.9
<OK> to stop