Electrohome EAAC475 - Operating Instructions; Connecting Power and Time Zones; Battery Backup Functionality

- 12 -
OPERATING INSTRUCTIONS
CONNECTING POWER
The USB Charging Alarm Clock Radio is equipped with an "AUTO TIME SET" feature.
When power is connected, the clock display will ash '2' which is TIME ZONE 2
(Eastern time) and the default TIME ZONE setting. The correct time will be displayed,
unless you are in another time zone.
To select TIME ZONE 2 (Eastern time) as your default time zone:
• Press ONCE to conrm your selection.
To change your time zone upon setup:
• Press / until your own time zone appears on the display; press ONCE to
conrm your selection.
To change your time zone after setup:
• Press and hold the SNOOZE/SLEEP/DIMMER button until numbers ash.
• Press / until your own time zone appears on the display; press ONCE to
conrm your selection.
There are 8 programmed times zones:
BATTERY BACKUP
This alarm clock is equipped with a battery backup feature. This feature will restore your
alarm clock settings in the event of a power outage. The 3V, CR2032 Flat Lithium battery
is pre-installed at the factory, however, should you need to replace the battery, please
read the following instructions.
Zone 0 - Newfoundland time
Zone 1 - Atlantic time
Zone 2 - Eastern time (default)
Zone 3 - Central time
Zone 4 - Mountain time
Zone 5 - Pacic time
Zone 6 - Alaska time
Zone 7 - Hawaiian time
OPERATING INSTRUCTIONS