22
Arranging the machine
• Wear protective gloves and unpack the machine.
• Lift the equipment with a lift truck, remove the base and
position it the place of use.
• Carefully remove the protective film from the outer panels
without tearing it, to avoid leaving traces of glue.
• Adjust the equipment by turning the special adjustable feet
and making sure it is perfectly level, both length wise and
crosswise.
• The appliance must be fixed to the floor using the two
clamps supplied.
– Accessing the appliance bottom panel.
– Fit the clamps on feet as shown in supplied technical
sheet.
– Screw the appliance steadily to the floor using hole
clamps.
E.6 Extraction hood
For models without Energy Saving Device [ESD], make sure
to install an extractor hood to remove the steam produced by
the machine.
For models with Energy Saving Device [ESD], it is not
necessary to install an extractor hood unless the current
regulations in the country of use require it.
The hood air flow must be calculated taking into account the
type of installation and the work environment where it is
installed.
In any case, an air flow rate of between 1000 m
3
/h and 1500
m
3
/h is recommended.
E.7 Disposal of packing
The packing must be disposed of in compliance with the
current regulations in the country where the appliance is used.
All the packing materials are environmentally friendly.
They can be safely kept, recycled, or burned in an appropriate
waste incineration plant. Recyclable plastic parts are marked
as follows:
To Next Page
