S31EUK4090SY(2)99-01
PREPARATION OF A NEW MACHINE
Insert the ignition key into the panel and turn it
clockwise: the display will show four zeros and
after a few seconds the battery voltage will
appear.
Push button A keeping it pressed a couple of
seconds.
The machine will first run trough a click-Off
sequence (indicator B lighting) and, after that,
the click-On sequence will be enabled (indicator
C lighting).
Now the machine is ready for click-On that can
be done by pressing button A again (two
seconds at least).
After the second action on button A the indicator
C will be On until the click-On will be completed.
Now the brushes are fitted.
A
B
C
A
C
12
To Next Page