Electrolux BE5 User Manual

3.1 OPERATION - SAFETY
Use, safety
Read all the instructions.
- The appliance must be used by trained professional personnel
having knowledge of this manual.
- Do not put machine in water or any other liquid to avoid any
risk of electric discharge.
- Disconnect the plug of the appliance when not in use or before
any maintenance operation or cleaning.
- Check that the appliance is in position 0 when:
- it is not in use
- before attaching or removing tools, accessories
- before cleaning.
- Remove accessories and tools from beater before washing
- Never touch moving parts.
- Keep hands, hair, clothing, spatulas and other utensils away
from the tools when in operation to reduce any risk of injury
and/or damaging the appliance.
- Do not use the machine if:
- the cable or plug is damaged
- the safety component (guard) is faulty.
- the appliance has fallen or shows signs of damage.
- The use of accessories not recommended or not sold by
the manufacturer could lead to fi re, electrical discharge or
injury.
- Do not use the appliance outdoors.
- Do not allow the cable to hang over the edge of the table or
a worktop.
- Do not allow the cable to touch a hot surface, including an
oven.
3.1
• Electrical characteristics machine :
2.3 ELECTRICAL CONNECTION
• This mixer-whisk is to be supplied with single-phase current.
• Provide an visible and accessible for the operator standardised
waterproof 2 pin + earth wall socket, rated 10-16 A. visible and
accessible for the operator.
• Check that the electric mains voltage and the value shown on the
specifi cation plate .
• Warning for the installer:
This electronic whisk is fi tted with a fi lter which sends any
interference from the mains to earth without going through the
variator. To work properly, the appliance earth connection must
be sound otherwise the interference may go through the variator
and damage it
NO EARTH = NO PROTECTION = RISK OF BREAKDOWN
Supply Power Frequency Current
voltage (V) (W) (Hz) (A)
BE5 : 230 450 50 2,5
BE8 : 230 600 50 4
• The machine must be protected by a differential circuit breaker
and a 10A fuse.
In certain circumstances depending on the sensitivity of the
protective cut-outs, it may be necessary to install SI-type (super
immunity) devices to prevent untimely triggering..
Note: The machine can only be used on TN
(earthing to neutral) and TT (earthed neu-
tral) type supplies. Where a machine has to
be installed on an IT (impeding or isolated
neutral) supply, there is a solution which consists
of inserting an isolating transformer and locally
putting on the machine on TN or TT supply.
- KEEP THESE INSTRUCTIONS
• The safety of the user is guaranteed by:
- The safety guide which stops the appliance when it is lifted.
- The machine only starting when the cradle is in the work po-
sition and the safety guard lowered the bowl is in position on
the cradle.
- A time of less than 4 seconds for the beater to stop regardless
of the speed.
- A no-volt release system requiring for the speed button to be
at 0 to start back up.
- Protection from current and voltage overloads and the motor
from heating.
G Rotary ON/OFF/VARIATION button
O Position 0 : OFF
I Position 1 to 12 . SPEED ADJUSTMENT
a) Electronic speed variation
- Turn the variation button:
Clockwise to increase speed.
Anticlockwise to reduce speed.
Note: Do not force the min. - max. stops of the button,
as this may damage the potentiometer.
b) Braked stop
- By bringing the variation button back to 0
Do not lift the safety guard up until the mixer has stopped
completely to prevent splashes
BE5 - BE8 GB 06 2015 2
Any other use than that described in this manual will not be
considered normal by the manufacturer.
Note: Non-compliance with these instructions may result
in invalidation of the warranty.
Do not use the machine without the bowl.

Electrolux BE5 Specifications

General

Brand	Electrolux
Model	BE5
Category	Kitchen Appliances
Language	English