SHOWER
LID/CHUTE
CONTROL
SWITCHES
C5.1 CLEANING THE UNIT
It is recommended that at the end of each shift or if the unit is to be shut down that it is cleaned manually.
Flushing through can be activated whilst running by holding the GREEN start button down.
Do not put any cleaning tools (brushes or rags) into the machine at any time. Wipe all external surfaces.
Use machine cleaning shower hose to wash the machine through this only operates whilst the machine is
running and for a further 2 minutes after its operating cycle. If residue deposits are still visible, repeat the
cleaning process.
Only use washing up liquid soap, suitable for dish washing, to clean the machine.
NEVER use abrasives strong detergents, pipe unblocking substances or bleach, as such products can cause
damage to internal components within the unit. Use of such will invalidate the warranty.
C5.2 DAILY MAINTENANCE (HYGIENE CHECK)
• Wipe machine’s external surfaces
• Wash through with liquid soap suitable for dish washing
• Flush Machine through using machine’s shower hose
• Empty Bin regularly, particularly at the end of a shift, and wash bin to remove residues.
• Clean waste outlet to waste receptacle.
• Open lid and check the Red service light is on and flashes, and machine isolates. If machine
isolates but light does not come on then replace light bulb. If machine does not isolate call
maintenance engineer.
Page 16 of 20
To Next Page
Loading...
Need help?
General