- 25 -
TSE-N 01.01 A. B. 599 50 86 62 EN
6.3 Measures to prevent wrong electrical connection
If a range with pyrolytic self-cleaning system is connected wrongly, the micro processor at the Pris-
ma basic power board recognises this error. It changes over into the fault mode. The fault is
displayed by flashing pilot lamps in the switch panel. The heaters are dead. The connection error
can be corrected. Then the range can be operated quite normally.
6.4 Thermal link
A thermal link is provided in all appliances at the left side at the air duct, which switches off the
device in case of overheating.
Fig. Versions of connection
Fig. Thermal link (Klixon)
To Next Page
Loading...
