FlexiBridge Big Bridge mode
To activate the mode press until you see
the correct mode indicator . This mode
connects the three rear sections into one
cooking area. The front section is not
connected and operates as a separate
cooking zone. You can set the heat setting for
each area separately. Use the two control
bars on the left side.
Correct cookware position:
Make sure to place the cookware on the three
connected sections. If you use cookware
smaller than two sections the control bar
blinks and after 2 minutes the zone
deactivates.
Incorrect cookware position:
FlexiBridge Max Bridge mode
To activate the mode press until you see
the correct mode indicator
. This mode
connects all sections into one cooking area.
To set the heat setting use any of the two
control bars on the left side.
Correct cookware position:
Make sure to place the cookware on the four
connected sections. If you use cookware
smaller than three sections the control bar
blinks and after 2 minutes the zone switches
off.
Incorrect cookware position:
20 ENGLISH
To Next Page
Loading...
