2. Set a heating function or setting.
3. Press again and again until the display
shows: Function Lock.
4. Press to confirm.
To turn off the function, press . The display
shows a message. Press again and then
to confirm.
When you turn off the oven, the function
also turns off.
10.4 Set + Go
The function lets you set a heating function
(or a programme) and use it later with one
press of any symbol.
1. Turn on the oven.
2. Set a heating function.
3. Press
again and again until the display
shows: Duration.
4. Set the time.
5. Press again and again until the display
shows: Set + Go.
6. Press to confirm.
Press any symbol (except for
) to start the
function: Set + Go. The set heating function
starts.
When the heating function ends, a signal
sounds.
• Function Lock is on when the heating
function works.
• The menu: Basic Settings lets you
turn the function: Set + Go on and off.
10.5 Automatic switch-off
For safety reasons the oven turns off after
some time, if a heating function works and
you do not change any settings.
(°C) (h)
30 - 115 12.5
120 - 195 8.5
200 - 230 5.5
The Automatic switch-off does not work with
the functions: Light, Duration, End Time.
10.6 Brightness of the display
There are two modes of display brightness:
Day brightness
Night brightness
It is on when the oven is
turned on.
When the oven is turned
off, the display is in night
brightness mode between
10 PM and 6 AM.
It is on for 10 sec when
you touch any sensor
field during the night
brightness mode.
It is on when the oven is
turned off and you set the
function: Minute Minder.
When the function ends,
the display goes back to
the night brightness.
10.7 Cooling fan
When the oven operates, the cooling fan
turns on automatically to keep the surfaces of
the oven cool. If you turn off the oven, the
cooling fan can continue to operate until the
oven cools down.
11. HINTS AND TIPS
Refer to Safety chapters.
ENGLISH 17
To Next Page
Loading...
