Electrolux ECH/AG2-1000 3BE EEC - Specifications

10
www.home-comfort.com
Troubleshooting
Malfunction
symptom
Cause of malfunction Troubleshooting steps
No heating
1) There is no power supply.
2) The convector is in standby mode.
3) The actual room temperature is higher
than the thermostat setting.
1) Establish a reliable connection.
2) Set the convector to operating
mode.
3) Adjust the temperature mode of the
convector.
Smell of burnt dust
when first turned on
Not a malfunction
The smell disappears after a few
minutes of convector operation
If after trying all the troubleshooting steps, the problem is not resolved, contact an authorized service cen-
ter in your area or your sales representative.
Specifications
Model
ECH/AG2-1000
3BE EEC
ECH/AG2-1500
3BE EEC
ECH/AG2-1800
3BE EEC
ECH/AG2-2200
3BE EEC
Power, W
900-1000 1350-1500 1600-1800 2000-2200
Rated power consumption, W 900-1000 1350-1500 1600-1800 2000-2200
Rated current, A 4.1-4.17 6.14-6.25 7.27-7.50 9.1-9.17
Rated voltage, V~Hz 220/240~50/60 220/240~50/60 220/240~50/60 220/240~50/60
Ingress protection class IP24 IP24 IP24 IP24
Electrical protection class I I I I
Heating area, m
2
10-12 13-15 18-20 22-25
Appliance size (W×H×D), mm 480×413×129 560×413×129 640×413×129 800×413×129
Packing size (W×H×D), mm 575×445×157 655×445×157 735×445×157 895×445×157
Net weight, kg 3.44 4.1 4.33 5.13
Gross weight, kg 4.57 5.13 5.43 6.63
* Indicated is a guideline value and may differ depending on actual conditions of use
The convector is supplied with a sticker on
the front panel. Remove it before using the
device.