32
CLEANING YOUR APPLIANCE
Removing and replacing the grill side runner
supports (models EXC693, EDC693, EDE693)
• Grasp the shelf supports in the middle.
• Pull them inwards.
Installing the lower oven shelf supports
• First insert the rear hook into the rear hole.
• Then locate the front peg into the front hole and push
in firmly.
Removing the grill drawer
(models EGC633, EGC653 & GGC643)
The grill carriage can be fully removed to allow
access for cleaning.
• Pull grill door fully out to stops and remove grill
dish.
• Raise the grill door to disengage stop pins.
(Make sure carriage is clear of rear pin before
lifting up)
• Grill carriage can now be removed from the
appliance.
NOTE: Ensure that the slides are pushed into
appliance when the carriage is removed.
Replacing the grill drawer
(models EGC633, EGC653 & GGC643)
Push slides fully into appliance, then:
• Engage back of grill carriage over rear pins (on
both sides).
• Lower the assembly...
• and push grill door closed.
The grill dish can now be replaced.
To Next Page
Loading...
