Electrolux EDW 1503 - Page 33

8.2.4. EDW 1500 Service function / disconnection pulse wash
General information Calling above-mentioned service function
w Calling the Service Functions is similar with all designs
Calling the function "Switch OFF Pulse Wash"
or key arrangements.
w Always use the keys S0
, S1, S2 and S3 independently
1.
Simultaneously press S1 and S3 and ...
from their program assignment depending on the model.
w In service function mode, you can ALWAYS call the
2.
... switch on the appliance with ON/OFF switch S0.
Pulse Wash function by using keys S2 and S3. Use key S2
Keep keys S1 and S3 pressed simultaneously
to modify the setting.
until the 3 acknowledging LEDs LD1, LD2 and LD3 are flashing.
( Short-time illumination of LEDs is possible and does not constitute any fault)
w From works settings, Pulse Wash is always set to be active.
3.
Simultaneously press S2 and S3 until the acknowledging LED
LD2
is flashing. LEDs LD1 and LD3 will go dark.
The current status whether Pulse Wash is active or not
is signaled in the display.
1P = Pulse Wash is active
0P = Pulse Wash is switched off
Switching the Pulse Wash Function on or off:
4. / 5.
Any further activation of function key S2 will
w
If you deselect Pulse Wash the rot. speeds of the cir-
switch the addition alternately on or off.
cul. pump are alw.increased to "High Pulse Speed".
Water consumption slightly increases.
Leaving the function
Extension of time is possible depending on the temperature.
After the last activation of function key S2 you can leave the
special program as follows:
After 60 seconds all displays go out automatically, except
LD0
of the ON/OFF key
or
the appliance is switched off by ON/OFF key S0.
Saving the status settings
Always applicable:
Immediately after each input of data, the currently valid status
In order to call the totality of service functions, always first
will be saved.
press the function keys S1 and S3 prior to switching the
appliance on by means of ON/OFF switch S0!
Keep the keys pressed for abt. 4 seconds in order to activate
the function. This procedure is intentionally distinguished
from those for the customer functions.
ATTENTION: In case of reduced key assemblies
be sure to observe Description Page B 1.
key arrangement
vertically
S1
S2
S3
LD1
LD2
LD3
1 99
S1
LD0
S0
LD0
LD1 LD2
S1 S2
1 99
LD3
S3
key arrangement
horizontally
... automatically OFF after 60 sec
... OFF by actuating ON/OFF manually
S0
LD0
3.
1P
S2
flashing
LD2 S2
S0
LD0
LD1 S1
LD3 S3
LD2 S2
S1
LD0
LD1 S1
LD3 S3
S0
LD0
4.
0P
LD2
S2
flashing
S0
LD0
5.
1P
LD2
S2
flashing
1.
S0
LD0
LD2
LD1
LD3
S1
S3
S0
LD0
2.
LD2
LD1
LD3
S1
S3
flashing
Keep keys S1/S3
pressed for abr. 4 sec.
until LD1-LD3 are flashing
S3
LD2