Electrolux EDW 1953 User Manual

SERVICE MANUAL
DISHWASHERS
SERVICE MODE & ALARM
CODES
Dishwashers with electronic
control system
 ELECTROLUX HOME PRODUCTS
Customer Care - EMEA
Training and Operations Support
Technical Support
Publication number
599 79 76 - 53
Edition: 05/2017 - Rev. 1.0
EN
• EDW 503
• EDW 1103
• EDW 1503
•
EDW 1753
• EDW 1953
• EDW 4013
• EDW 4033
599 79 76 - 53 REV 1.0

Electrolux EDW 1953 Specifications

General

Type	Freestanding
Washing class	A
Drying class	A
Delay Start	Yes
Dimensions (H x W x D)	850 x 600 x 600 mm

Summary

EDW503 Appliance Overview

Reset and Service Mode Entry

Procedures for resetting the appliance and entering service mode.

EDW503 Service Diagnostics

LED Test and Alarm Memory Management

EDW503 Test Cycles and Settings

Functional Test Cycle Operation

EDW1103 Control Interface

Reset and Service Mode Access

Procedures for resetting and accessing Service Mode on EDW1103.

EDW1103 Service Mode Diagnostics

Alarm Reading and Actuator Testing

How to access alarm codes and perform actuator tests.

EDW1103 Service Mode Functions

Diagnostic Tests and Memory Operations

EDW1503 / EDW1753 Service Mode Access

Alarm and Actuator Testing Procedures

Procedure for alarm reading and actuator tests.

EDW1503 / EDW1753 Service Functions

Diagnostic Tests and Settings Management

EDW1953 Service Mode Access

Entering Service Mode

Step-by-step guide to access Service Mode for EDW1953.

Alarm and Actuator Testing

Procedure for alarm reading and actuator tests.

EDW1953 Service Functions

Diagnostic Tests and Memory Management

EDW 4013 / EDW4033 Service Operations

Service Mode Access and Navigation

Steps to enter Service Mode and navigate functions.

Alarm Codes Introduction

Specific Alarm Code Descriptions

Details specific alarm codes like i00 (Low mains voltage) and i10 (Water Tap Closed).

Alarm Codes - Water and Pressure Issues

Filling, Draining, and Aqua Control Alarms

Analogue Pressure Sensor Alarms

Alarm Codes - Motor and Power Issues

Washing Pump and Motor Alarms

Details alarms i50-i54 related to washing pump (WP) and BLDC motors.

Power, Voltage, and Connection Alarms

Alarm Codes - Motor Current and Overload

Motor Current Faults and Plausibility

Explains alarms i59-i5F concerning motor current readings and plausibility.

Over Temperature and Overload Alarms

Alarm Codes - Heating and Thermistor Issues

Heating Element and Relay Faults

Thermistor and Door Mechanism Alarms

Alarm Codes - Configuration and Sensor Issues

Water Reuse and Configuration Alarms

Turbidity Sensor and Calibration Alarms

Alarm Codes - Turbidity and Communication Failures

Turbidity Sensor Calibration Errors

Details alarms iB0-iB4 related to turbidity sensor calibration.

Communication Problem Alarms

Covers alarms iC0-iC3 for communication issues between components.

Alarm Codes - Tacho and Water Level Problems

Tacho Signal and Motor Speed Alarms

Water Level Sensing Alarms