EDW503
Functional Test Cycle
1. After Service mode is accessed (when L1 is blinking, L2 and L3
is on), press S1 twice before L2 and L3 is turned off
LED L3 is blinking, L1 and L2 is turned on
2. Wait till L1 and L2 is turned off, then press S1 and close the
door.
The cycle starts and runs the same as a normal cycle
LED L3 blinks for the duration of the cycle
3. The cycle and be cancelled or run to its end.
Enable/disable Extra Rinse
Not available for this User Interface.
Enable/disable Pulse Wash
Not available for this User Interface.
Technical Support – A.R. Chapter 3.1
To Next Page