Need help?Do you have a question about the Electrolux EDW 503 and is the answer not in the manual?
General| Type | Freestanding |
|---|---|
| Installation | Freestanding |
| Place settings | 13 |
| Delay start | Yes |
| Programs | Eco, Quick, Rinse |
| Dimensions (H x W x D) | 85 x 60 x 60 cm |
Details the power output and resistance of the heating element.
Depicts the drain pump and circulation pump for water movement.
Shows the salt container, regeneration container, and regeneration valve.
Explains the fine strainer's perforated plate, function, and seal importance.
Explains how the pressure switch interacts with the container to close the inlet valve.
Details the drain pump's motor, housing, power, capacity, and jam-proof design.
States the power rating of the heater elements used for water heating.
Explains the safety system's conditions for activation and tripping to prevent overheating.
Describes built-in protections that burn off if the element operates without cooling water.
Shows connections for the regeneration valve (S3) and salt switch (b9).
Shows the intricate wiring connections to the main electronic control unit.
Shows the specific wiring connections related to the water softener unit.
Explains the importance and method for cleaning the coarse and fine filters.
Illustrates location of thermostats, switches, heating element, and EDW 503 unit.
Addresses low water level causes, like clogged containers, and adjustment of level switches.
Troubleshooting for drain pump running constantly due to the water protection device.
To Next Page