IMPORTANT
Please read all safety instructions before using your
new front-loading washer. For best washing results
with your new washer, remember to review:
9
INSTALLATION INSTRUCTIONS
9
USE & CARE GUIDE
NOTE TO
INSTALLER
Leave these instructions
with the customer.
IMPORTANT
This washer requires periodic cleaning
maintenance. Refer to cleaning instruc-
tions included with the unit literature.
CAUTION
EXCESSIVE WEIGHT HAZARD
Avoid back or other injury. Use more than one
person to move, tip or lift the washer.
ELECTRICAL SHOCK HAZARD
Washer must be properly grounded at all times.
REMARQUE POUR
L’INSTALLATEUR
Laissez ces instructions au
client.
Suite de la version française au verso.
NOTA AL
INSTALADOR
Deje estas instrucciones
con en cliente.
Español continua en la pagina trasera.
137269700A (0911)
For toll-free telephone support in the U.S. and Canada:
1-877-4ELECTROLUX (1-877-435-3287).
For online support and product information,
visit http://www.electroluxappliances.com.
Para obtener asistencia telefónica gratuita en los Estados Unidos y Canadá:
1-877-4ELECTROLUX (1-877-435-3287).
Para obtener asistencia e información en Internet sobre el producto,
visite http://www.electroluxappliances.com.
Pour rejoindre le service sans frais aux États-Unis et au Canada:
1-877-4ELECTROLUX (1-877-435-3287).
Pour obtenir de l’aide et de l’information sur les produits en ligne,
visitez le site http://www.electroluxappliances.com.
USE ONLY LOW-SUDSING, HIGH
EFFICIENCY DETERGENT.
UTILISEZ UN DÉTERGENT
HAUTE EFFICACITÉ QUI
PRODUIT PEU DE MOUSSE.
UTILICE UN DETERGENTE PARA
ROPA QUE PRODUZCA POCA
ESPUMA Y QUE SEA DE ALTA
EFICIENCIA.
ADJUST
LEVEL BOTH WAYS
CHECK STABILITY,
CORNER-TO-CORNER
raise
lower
A)
B)
C)
LEVEL
B)
C)
D)
E)
F)
G)
H)
A)
DETERMINE
HOT SUPPLY
TURN ON WATER,
CHECK FOR LEAKS
WRAP DRAIN HOSE,
SNAP IN PLACE
SECURE DRAIN HOSE WITH
SUPPLIED CABLE TIE
CONNECT TO GROUNDED
OUTLET, DO NOT REMOVE
GROUNDING PRONG
TIGHTEN ADDITIONAL
2/3 TURN WITH PLIERS
INSTALL HOT HOSE ON HOT
SUPPLY, COLD HOSE ON
COLD SUPPLY (HAND-TIGHT)
INSPECT FOR RUBBER
WASHERS
24” min
(60cm min)
CONNECT
Perform brief installation cycle for your model as follows:
Empty washer drum and close door.1.
Wake washer up (any button), rotate cycle knob to 2. hand wash, press start then
cancel.
Wake washer up again, immediately and simultaneously press and hold 3. eco friendly
and my favorite buttons for 5 seconds.
LCD will display 4.
INSTAL CYCLE and show estimated time of cycle completion.
Press start.
Installation Cycle will perform various diagnostic routines.5.
At cycle completion, LCD will display 6.
INSTAL PASS! or prompt an action dur-
ing cycle such as
CHECK HOSES, NO WATER or CALL SERVICE 877 435
3287
.
Washer will exit the Installation Cycle and return to normal operation next time you 7.
wake it up. Read Use and Care Guide and enjoy your new premium washer!
Empty washer drum and close door.1.
Wake up the washer by pressing any button and then follow the prompts on the 2.
LCD User Interface, including language selection. NOTE: this initial, automatic cycle
can be manually accessed through the scroll buttons in the set prefs sections
under options.
LCD will display3.
INSTAL CYCLE
and show estimated time of cycle completion.
Press start.
Installation Cycle will perform various diagnostic routines.4.
At cycle completion, LCD will display5. INSTAL PASS! or prompt an action during
cycle such as CHECK HOSES, NO WATER or CALL SERVICE 877 435 3287.
Washer will exit the Installation Cycle and return to normal operation next time you wake it 6.
up. Read Use and Care Guide and enjoy your new premium washer!
If washer has
this console:
If washer has
this console:
To Next Page
Need help?
General
Weight and Dimensions
