installation instructions
Connecting drain and electrical
,
Locate the anti-siphon ring shipped with your
washer. Place it over the end of the drain hose and
slide it past the first ring of "accordion" ribs.
Form a "U" shape on the end of the drain hose with
the hose pointed toward the drain. Place the formed
end in a laundry tub or a standpipe and secure the
drain hose with the cable tie (provided in the enclo-
sure package) to the standpipe, inlet hose, laundry
tub, etc. so the hose does not pull out from the force
of the water.
\
SLIDE DiSC
TO HERE
3. Plug the power cord into a grounded outlet.
Groundi
wallrece
Powercordwith
3_pronggrounded p!ug
CABLE TIE
/
/
4. Turn on the power at a circuit breaker/fuse box.
5. Carefully slide the washer to its final position. Re-
check for level and rock corners for stability. Re-
move and discard door tape.
6. Read the Use & Care Guide provided with the
washer. It contains valuable and helpful information
that will save you time and money.
7. See the next page about performing a brief, helpful
"Installation Cycle" on your new washer.
8. If you have any questions during initial operation,
please review the "Service Prevention Checklist" in
your Use & Care Guide before calling for service.
9. Place these instructions in a location near the
washer for future reference.
To Next Page
Loading...
