EasyManua.ls Logo

Electrolux EIGD55H - Electrical System Requirements

Electrolux EIGD55H
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IInnssttaallllaattiioonn IInnffoorrmmaattiioonn
2-8
EElleeccttrriiccaall SSyysstteemm RReeqquuiirreemmeennttss
Circuit - Individual 30 amp. branch circuit fused
with 30 amp. time delay fuses or circuit breakers.
Use separately fused circuits for washer and dryer.
DO NOT operate a washer and a dryer on the
same circuit.
Power Supply - 3-wire or 4-wire, 240 volt,
single phase, 60 Hz, Alternating Current.
33--WWiirree PPoowweerr SSuuppppllyy CCoorrdd KKiitt ((nnoott ssuupppplliieedd))
The dryer MUST employ a 3-conductor power
supply cord NEMA 10-30 type SRDT rated at
240 volt AC minimum, 30 amp, with 3 open end
spade lug connectors with upturned ends or
closed loop connectors and marked for use with
clothes dryers. For 3-wire cord connection
instructions see ELECTRICAL CONNECTIONS
FOR A 3-WIRE SYSTEM.
44--WWiirree PPoowweerr SSuuppppllyy CCoorrdd KKiitt ((nnoott ssuupppplliieedd))
The dryer MUST employ a 4-conductor power
supply cor
d NEMA 14-30 type SRDT or ST (as
required) rated at 240 volt AC minimum, 30 amp,
with 4 open end spade lug connectors with
upturned ends or closed loop connectors and
marked for use with clothes dryers. For 4-wire
cord connection instructions see ELECTRICAL
CONNECTIONS FOR A 4-WIRE SYSTEM.
NOTE
BBeeccaauussee ooff ppootteennttiiaallllyy iinnccoonnssiisstteenntt vvoollttaaggee
ccaappaabbiilliittiieess,, tthhee uussee ooff tthhiiss ddrryyeerr wwiitthh ppoowweerr
ccrreeaatteedd bbyy ggaass ppoowweerreedd ggeenneerraattoorrss,, ssoollaarr ppooww--
eerreedd ggeenneerraattoorrss,, wwiinndd ppoowweerreedd ggeenneerraattoorrss oorr
aannyy ootthheerr ggeenneerraattoorr ootthheerr tthhaann tthhee llooccaall uuttiilliittyy
ccoommppaannyy iiss nnoott rreeccoommmmeennddeedd..
GGFFII ((GGrroouunndd FFaauulltt IInntteerrrruupptteerr)) rreecceeppttaaccllee iiss
nnoott rreeqquuiirreedd..
NOTE
DDrryyeerrss mmaannuuffaaccttuurreedd ffoorr ssaallee iinn CCaannaaddaa hhaavvee
ffaaccttoorryy--iinnssttaalllleedd,, 44--wwiirree ppoowweerr ssuuppppllyy ccoorrdd
((NNEEMMAA 1144--3300RR))..
IMPORTANT
TThhiiss ddrryyeerr iiss iinntteerrnnaallllyy ggrroouunnddeedd ttoo nneeuuttrraall
uunnlleessss iitt wwaass mmaannuuffaaccttuurreedd ffoorr ssaallee iinn CCaannaaddaa..
GGrroouunnddiinngg tthhrroouugghh tthhee nneeuuttrraall lliinnkk iiss pprroohhiibbiitteedd
ffoorr:: ((11)) nneeww bbrraanncchh cciirrccuuiitt iinnssttaallllaattiioonnss,, ((22))
mmoobbiillee hhoommeess,, ((33)) rreeccrreeaattiioonnaall vveehhiicclleess,, aanndd ((44))
aarreeaass wwhheerree llooccaall ccooddeess ddoo nnoott ppeerrmmiitt ggrroouunndd--
iinngg tthhrroouugghh tthhee nneeuuttrraall..
OOuuttlleett RReecceeppttaaccllee
NEMA 10-30R or NEMA 14-30R receptacle to be
located so the power supply cord is accessible
when the dryer is in the installed position.
EElleeccttrriiccaall RReeqquuiirreemmeennttss ffoorr GGaass DDrryyeerr::
Circuit - Individual, properly polarized and
grounded 15 amp. branch circuit fused with 15
amp. time delay fuse or circuit breaker.
Power Supply - 2-wire, with ground, 120 volt,
single phase, 60 Hz, Alternating Current.
Power Supply Cord - The dryer is equipped
with a 120 volt 3-wire power cord.
Grounding Connection - See “Grounding
requirements” in Electrical Installation section.

Other manuals for Electrolux EIGD55H

Related product manuals