IInnssttaallllaattiioonn IInnffoorrmmaattiioonn
2-16
RReevveerrssiinngg DDoooorr
PPrreeppaarriinngg ttoo RReevveerrssee DDoooorr SSwwiinngg
1. Be sure you have adequate swing area before
reversing door.
2. You will need a screw driver with a #2 square
bit.
3. Protect flat work surface, such as top of
washer or floor near washer, with a soft cloth
or towel.
4. Be sure washer is unplugged from power
source.
RReemmoovviinngg TTrriimm RRiinngg
1. Open the door to a 90 degree angle.
2. Remove and save the trim plug and long,
course-thread, panhead screw.
(See Figure 2-17)
3. Close the door.
4. Rotate the door trim approximately ¾”
counter-clockwise and pull it away from the
front of the door. (See Figure 2-18)
RReemmoovviinngg DDoooorr ffrroomm HHiinnggee
1. Reopen door to 90 degree angle.
2. Remove 4 long, course-thread, counter-sunk
hinge screws from door. (See Figure 2-19)
3. While supporting the weight of the door with
both hands, separate the door from the hinge.
(See Figure 2-20)
4. Gently place the door face down on a flat,
covered work surface.
FFiigguurree 22--1177..
FFiigguurree 22--1188..
FFiigguurree 22--1199..
FFiigguurree 22--2200..
To Next Page
Loading...
