Electrolux EIS8648 - Page 18

the previous heat setting to activate
the function.
To leave the Menu, touch or the right
side of the display, outside of the pop-up
window. To navigate through the Menu,
use or .
To stop the function, touch the zone
selection symbol and then touch Stop.
6.12 Pause
This function sets all cooking zones that
operate to the lowest heat setting.
You cannot activate the function when
Assisted Cooking or Sous Vide is
running.
When the function operates only
and
symbols can be used. All other
symbols on the control panel are locked.
The function does not stop the timer
functions.
Touch
to activate the function.
comes on. The heat setting is lowered
to 1.
To deactivate the function touch .
The function stops PowerBoost. The
highest heat setting reactivates when
you touch again.
6.13 Timer
+STOP
Count Down Timer
Use this function to specify how long a
cooking zone should operate during a
single cooking session.
You can set the function for each
cooking zone separately.
1. Set the heat setting for the
appropriate cooking zone first and
then set the function.
2. Touch the zone symbol.
3. Touch
.
The timer menu window appears on the
display.
4. Check
to activate the function.
The symbols change to
+STOP
.
5. Slide your finger to the left or right to
select the desired time (e.g. hours
and/or minutes).
6. Touch OK to confirm your selection.
You can also choose to cancel your
selection.
When the time comes to an end, a signal
sounds and blinks. Touch to stop
the signal.
To deactivate the function set the heat
setting to 0. Alternatively, touch
+STOP
to the
left of the timer value, touch next to it
and confirm your choice when a pop-up
window appears.
Minute Minder
You can use this function when the hob
is activated but the cooking zones do not
operate.
The function has no effect on the
operation of the cooking zones.
1. Select any cooking zone.
The relevant slider appears on the
display.
2. Touch
.
The timer menu window appears on the
display.
3. Slide your finger to the left or right to
select the desired time (e.g. hours
and minutes).
4. Touch OK to confirm your selection.
You can also choose
to cancel your
selection.
When the time comes to an end, a signal
sounds and
blinks. Touch to stop
the signal.
To deactivate the function touch to
the left of the timer value, touch
next
to it and confirm your choice when a pop-
up window appears.
Stopwatch
The function automatically starts
counting immediately after you activate a
cooking zone. You can use this function
to monitor how long it operates.
1. Touch to access the Menu.
www.electrolux.com18