Electrolux EKF3330 - English

6www.electrolux.com
ENGLISH
Thank you for choosing an Electrolux product. In order to ensure the best results, always use original
Electrolux accessories and spare parts. They have been designed especially for your product. This product
is designed with the environment in mind. All plastic parts are marked for recycling purposes.
COMPONENTS
A. ON/OFF switch with power indicator light
B. Water tank
C. Water level indicator
D. Hinged lid
E. Filter holder with anti-drip valve
F. Coee jug with graduation on both sides
G. Warming plate
H. Power cord & plug
Picture pages 2-3
GETTING STARTED
1 Place the machine on a at surface. When starting the machine for the rst time, ll the tank with cold
water. Start the machine with the ON/OFF switch. Let a full tank of water pass through the machine once
or twice to clean it, without using paper lter or coee.
2 Making coee: open the lid and ll the water tank with fresh cold water up to the desired level. There is
a gauge for cups on the water tank and on the coee jug. (The machine must not be used with empty
tank!)
3 Insert a size 1x4 paper lter in the lter holder and ll it with ground coee. For average strong coee
one measuring spoon (approx. 6-7 g) per cup is sucient. Close the water tank lid and place the jug
(complete with lid) onto the warming plate.
4 Start the machine with the ON/OFF switch. The power indicator light will come on and hot water will
ow into the lter. When water has stopped owing, the warming plate keeps the coee hot until the
machine is turned o with the ON/OFF switch. If the machine is not turned o manually, the Safety
Auto-O function turns it o after 40 minutes.
5 If the jug is removed, the lter valve prevents coee from dripping onto the warming plate. (While boil-
ing, the jug must not be removed for longer than 30 seconds or the lter will overow.)
CLEANING AND CARE
6 Turn the machine o and unplug the power cord. Wipe all outer surfaces with a damp cloth. Coee
jug and jug lid are dishwasher proof. Never use caustic or abrasive cleaners, and never immerse the
machine in liquid!
7 To clean the lter holder, lift up the handle and remove the lter holder. To clean the lter valve thor-
oughly, rotate it several times while it is being rinsed.
8 Decalcifying is recommended regularly, depending on water hardness. Fill the tank with water and
decalcier according to product instructions, then follow steps 9 and 10.
9 Place the coee jug with its lid onto the warming plate. Allow the decalcier to take eect for about
15 minutes, then switch the machine on. Switch it o when the solution has nished owing through. If
necessary repeat the decalcifying process.
10 Allow the machine to run at least twice with plain water. Then thoroughly rinse the coee jug, lid and
lter holder under running water, activate the lter valve repeatedly during the rinse process.
Enjoy your new Electrolux product!