• As affixing an end of hose to the detector, other end to the gas entrance
adaptor of oven tightly, hold it with a sheet iron pipe collar and screwdriver
very tightly. If no connection is made with hose in limitation of conditions
that were explained above, flexible metal hose can be used. It is required to
contact to the authorized service to be able to connect appropriately at
security standards on this condition and a technician must do this
connection.
• Your cooker is adjusted to operate by LPG.
• The flexible hose must not come in contact with sharp edges and there must
be no damage.
ATTENTION!!!
Do not use any match and lighter for control of gas leakage.
Adjusting The Reduced Flame Position :
I
n appliances equipped with Flame Failure Devices and microswitches at the
same time,the control panel should be removed in order to reach the
adjusting screw safely.
For reduced flame position the by pass screw must be loosened in
transformation from LPG to NG. In transformation from NG to LPG, the same
screw must be fastened. Make sure that the appliance is unpluged from the
electric current and the gas feed is open.
Ignite the burners and leave them on in minimum position. Remove the knobs
because the screws are accesible only when the knobs are removed.
With the help of a small screwdriver fasten or loosen the by pass screw 90
0
,
which makes the flame of the burner come down to the minimum (Figure 6).
When the flame has a length of at least 4mm, the gas is well distributed.
Make sure that the flame does not die out when passing from the maximum
position to the minimum position.
Changing the Gas Inlet :
The gas feeding pipe which comfirms to the regulations on effect “A” placed
on pipe support must be visible for all its lenght, it must be placed with great
attention to avoid any contact with parts that will heat up. It is necassary to
block the pipe with a griddle.
To Next Page
Loading...
