3
A. Belt & Brushroll Assembly Removal / Installation
•
Remove 3 Phillips screws from bottom plate.
•
Remove bottom plate.
•
Lift brushroll out and remove the belt.
•
Remove the belt from the brushroll motor pulley.
•
Reassemble in reverse order.
•
To ease the installation of the brushroll install the belt side first, and make sure you
rotate the brushroll to make sure it rotates smoothly.
B.
Rear Wheel Assembly Removal / Installation
•
Remove hub cap by prying off gently with a flat tip screwdriver.
•
Remove torx screw and lock washer
•
Remove Wheel Assembly
•
When reinstalling wheel assembly insure large anti wear washer is installed between the
wheel and the handle retaining ring.
•
Reassemble in reverse order.
C.
Hood Assembly Removal / Installation
•
Remove the belt & brushroll. (Section A)
•
Remove 4 torx screws from under brushroll.
•
Remove left wheel (Section B)
•
Remove 2 torx screws at (1 and 11o’clock) on handle retaining ring.
•
Remove the left and right fenders by gently prying them with a flat tip screwdriver.
•
Remove 2 torx screws from under the left fender.
•
Remove 1 torx screw from under the right fender.
•
Remove the bag cover and gasket.
•
Remove HEPA filter.
•
Remove 2 torx screws from the forward edge of bag compartment.
•
Remove 4 torx screws from around HEPA filter.
•
Remove the hood assembly.
•
Reassemble in reverse order. When placing hood back on the unit be sure to install the
cord guide/stop on the hood before fully setting it on the unit.
To Next Page
Loading...
