EMS2020
í===========================================
English
8
1. Remove any promotion label from the door.
2. The oven s h ould be installed on a flat, level
surface. The surface must be strong enough to
safel y bea r the weight (13.5 kg) of th e oven, and
the c ontents. To a void the possibility of causing
vibration or noise the oven must be in a stable
position.
3. Keep the ove n away from heat and w a ter.
Exposure to heat and water can lower oven
efficiency and lead to malfunctioning, so be sure to
install the ove n away from heat and water sources.
4. Do not block air vents on the top and the sides of
the cabi n et and also do not place any articles on
the top of the oven. If air vents are blocked during
operation, the o ven may overheat, a nd this may
lead to malfunctioning. Hot air escapes from the
vents, so be sure not to obstruct it or let curtains
come between the oven and the rear wall.
5. Place the oven as far away from radios and TV’s
as possible. This oven does conform to EEC
requirements of radio interference suppression, but
some interference may occur if it is placed too
close to a radio or TV, so keep them as fa r apart
as possible.
6. If positioned in a corner, leave a gap of at least
10 cm from the walls and 10 cm above the
microwave.
IMPORTANT!
The oven can be placed almost
anywhere in the kitc hen. Make sure the oven is
placed on a flat, level surface and that vents as
well as the surface underneath the ove n are not
blocked (for sufficient ventilation).
Con necting to th e mains
The oven is delivered with the power cord and a plug
for 230V, 50Hz, earthed socket outlet.
Earth protection mi nim ises the risks should a short
circuit occur. Check to ensure the voltage of the oven
matc hes the supply.
N.B. If the ove n is connected to the socket via an
extension cord, make sure the cord is earthed.
m
This appliance must not be used o n a non-
earth protected power supply. Conta ct an
electrician if you are u ncertain reg arding
electrical connection o f the oven or provision of
earth protection of the
supply.
m
This appliance must be earthed. If t his
appliance is fitted with a non-rewireable plug
for which your socket is unsuitable, it must be
replaced by the manu facturer, its service agent
or similarly qualifie d perso ns in order to avoid a
hazard.
m
If the supply cord is damaged, it must be
replaced by the manufact urer, its service agent
or similarly qualifie d perso ns in order to avoid a
hazard.
Installation.
To Next Page
Loading...
