EasyManua.ls Logo

Electrolux EOB33100 - Oven Door Glass Re-installation; Re-fitting Door Glass Panel

Electrolux EOB33100
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
electrolux 27
4. Take hold of the door trim (B) on the up-
per edge of the door at both sides and
press inwards to release the clip seal.
Then remove the door trim by pulling
upwards.
5. Take hold of the door glass on its upper
edge and take it out of the guide by pull-
ing it upwards.
Cleaning the door glass
Clean the door glass thoroughly with a solu-
tion of water and washing up liquid. Then dry
it carefully.
Putting the door glass back
1. From above insert the door glass at an
angle into the door profile at the bottom
edge of the door and lower it.
2. Take hold of the door trim (B) at each
side, position it on the inside edge of the
door and plug the door trim(B) into the
upper edge of the door.
3 On the open side of the door trim (B)
there is a guide bar (C). This must be
pushed between the outer door panel
and the guide corner(D).
The clip seal (E) must be snapped in.
3. Open the oven door as far as it will go.

Related product manuals