54 electrolux cleaning and care
Putting the door glass panels back.
1. From above insert the door glass
panels one after the other into the
door profile at the bottom edge of
the door at an angle and lower them.
The two smaller panels first, then
the larger panel.
2. Take hold of the door trim (B) at each
side, position it on the inside edge of
the door and plug the door trim (B)
into the upper edge of the door.
On the open side of the door trim (B)
there is a guide bar (C). This must be
pushed between the outer door
panel and the guide corner (D).
The clip seal (E) must be snapped in.
To Next Page
Loading...
