Glass Shelves
When removing the glass shelf, please press the movable
pin under the shelf with both hands and push inward at the
same time. Then the glass shelf will be removed.
10 Features of your refrigerator
Features of your refrigerator
This section tells you how to make the most of the many
useful features and how to clean them.
Door storage bins
Door bottle shelf removal:
After removing all contents from the shelf, squeeze
together the two top outside corners of the clear plastic
shelf (close to the white door liner), then pull the
shelf horizontally away from the door and out of the shelf
supports. To reinstall the shelf, squeeze together the two
top outside corners of the clear plastic shelf near the clips /
open section, pushing the shelf horizontally back into the
shelf support on the door white plastic liner. Check the shelf
has been securely attached before loading with bottles /
food.
Crisper Bin
You can use the crisper bin to store vegetables, fruit
or smallgoods. To remove, pull it forward then up and out.
Gl
ass shelve
liner of cabinet
Glass shelve
liner of cabinet
Here is a groove on the liner
liner of door bottle
shelf
Instructions for child lock lever
Press the child's lock lever with your thumb as the direction as
below ① and the water lever ② will be locked to prevent children
from taking any water.
Press in the opposite direction to unlock and take water
Instructions for water tank assembly
MAX
2L
1.Hold both sides of the tank with hands and pull
the tank assembly off the door slightly in the
direction indicated as below.
Notes: This transparent silicone parts used to
seal the water tank. When you clean the water
tank, this part does not need to be disassembled.
If it is removed, when installing the water tank,
please seal the silicone well before installing the
water tank.
1-1.Align the transparent silicone part with the
hole in the door and place it in it.
1-2.After the transparent silicon is inserted into
the hole, push it down until it touches the
intercepting surface in the hole and cannot be
pushed; to prevent water leakage
2.Rotate counterclockwise to remove the water
valve assembly from the water tank for
cleaning.
3.Pinch the flange of the water tank cover
slightly upwards, and the water tank cover can be
separated from the water tank. Remove the other
side with the same method .The tank and its cover
can be cleaned after disassembly.
4.Install the water valve by rotating it clockwise
after cleaning. When installing the tank cover,
install the one side at first (do not press it all the
way), then install the other side. Press firmly on
edges of the tank cover to fit the tank. Re-install
the entire water tank assembly at 45° to the
door. Press the outer edge of the water tank
slightly downwards to make it fit into the door.
Fill the tank with clean drinking water( * )
1
MAX
2L
Open the inlet cover of water tank①.
Slowly fill the tank with pure drinking
water up to the maximum fill line marked
with “2L”. Then close the inlet cover①.
To prevent any spills, please use a
narrow-spout container to charge
water.
*
Only drinking water or mineral water can
be stored in the water tank ,not suitable for any
other beverages
LED lighting
Your refrigerator is fitted with long life LED lighting.
In the unlikely event the LED lights should fail, then the LED
lights should be serviced by the manufacturer, its service
agent or similarly qualified technician. Refer to the
warranty page for contact details.
To Next Page
Loading...
