EEllektromos csatlakoztatás
MielŒtt a készülék csatlakozó dugóját csatlakoztatná
a fali dugaszoló aljzathoz, ellenŒrizze, hogy a helyi
hálózati feszültség megfelel-e a mıszaki adatokban
megadott feszülségértéknek. A feszülség +-6% kal
térhet el a megadott értéktŒl.
A megadottól eltérı feszültségı hálózatra csak
megfelelŒ adapter beiktatásával szabad rákötni a
készüléket.
A készüléket földelni kell.
A készülék elsŒ érintésvédelmi osztályú, csak
megfelelŒ védŒföldeléssel ellátott fali dugaszoló
aljzatról mıködtethetŒ.
A csatlakozó vezeték nem hosszabbítható meg. Ha
rövid, ki kell cserélni egy hosszabb kábelre vagy a
dugaszoló aljzatot kell áthelyezni, kizárólag
szakember segítségével.
A gyártó cég elhárítja a felelŒsséget minden olyan
esetleges balesetért, amely ezen biztonsági
elŒírások be nem tartásából származik.
Ez a készülék megfelel az alábbi Közös Piaci
rendeleteknek:
- 87/308/EEC
az Európai Közös Piac
(EEC)1987.VI..2. -án kelt, a rádióinterferenciákról
szóló elŒírásai.
- 73/23 EEC
1973.II.19 (Alacsony
villamosfeszültség) és kiegészitŒ elŒirások
- 89/336 EEC
1989.V.3 (Elektromágneses
kompatibilitás) és kiegészitŒ elŒirások.
47
About 6 hours
previously
About 24 hours
previously
Not required
Not required
Introduction of small quantities of fresh
food (around 5 Kg):
Introduction of maximum quantity of
fresh food (see serial no. plate):
Introduction of frozen food:
Introduction of small quantities of fresh
food (up to 2 Kg per day):
J. Temperature indicator
During normal operation, the average temperature of the
freezer section is displayed.
Attention!
A difference between the displayed temperature and the
set temperature is normal. In particular when:
- the set temperature has recently been modified
- the door has been open for a long time
- hot food has been put in the freezer.
Differences of up to 5°C inside the section are normal.
M. Frostmatic warning light
N. Frostmatic function button
To freeze fresh food it is necessary to activate the
Frostmatic function. Press button (N). Warning light (M)
lights up.
If you want to interrupt the rapid freezing function, press
button (N) again, otherwise the function switches off
automatically. Warning light (M) goes out.
Attention!
When to use the Frostmatic function:
Conservation of deep-frozen food
At the time of startup or after a period out of action,
place the food in the appliance after having run it for
at least two hours in Action Freeze mode, then take
it out of this mode.
Important
In the event of accidental thawing, for example
through interruption to the power supply, if the
length of the period of interruption is higher than
the value indicated in the technical data table
under the heading "recovery period", it will be
necessary to consume the food rapidly or to
cook it immediately and refreeze it (once it has
cooled down).
Freezing fresh food
The section is suitable for freezing fresh
food and for long-term conservation of frozen and
deep-frozen food.
For freezing fresh food, activate the Action freeze
function at least 24 hours in advance.
Place the food to be frozen in the top section as it is
the coldest point.
O. Alarm warning light
P. Alarm disarming button
An abnormal rise in the temperature of the freezer
section (e.g. electrical power failure) is indicated by
warning light (O) flashing, and by an audible signal.
When conditions return to normal, the audible signal will
switch off, while the alarm warning light continues to
flash.
If the alarm button (P) is pressed, the indicator (K)
displays for a few seconds the warmest temperature
reached in the section. The audible signal, if sounding,
will switch off.
Startup and temperature
adjustment
• Insert the plug in the mains socket. Press button
(I). The freezer section is now running. The
freezer section is set to a temperature of -18°C.
This temperature will be reached in several
hours.
• As soon as the freezer is running, the indicator
(K) displays the current temperature in the
freezer, the alarm warning light (O) flashes and
the audible signal is activated.
• Press the alarm button (P)
• The audible signal switches off, while the alarm
warning light (O) continues to flash until the set
temperature is reached.
To Next Page
