1. Open the doors. Unscrew the middle
hinge (m2). Remove the plastic spacer
(m1).
m1
m2
m3
m4
m5
m6
2. Remove the doors.
3. Remove the spacer (m6) and move to
the other side of the hinge pivot (m5).
4. Remove using a tool the cover (b1).
Unscrew the lower hinge pivot (b2) and
the spacer (b3) and place them on the
opposite side.
5. Re-insert the cover (b1) on the opposite
side.
b1
b2
b3
6. Remove the stoppers (1) and move to
the other side of the doors.
1
7. Unscrew the upper hinge pivot (t1) and
screw it on the opposite side.
8. Remove the left-hand cover pin of the
middle hinge (m3,m4) and move to the
other side.
9. Fit the pin of the middle hinge (m5) into
the left-hand hole of the lower door.
10. Re-insert the lower door on the lower
hinge pivot (b2).
11. Fit the upper door on the upper hinge
pivot (t1).
12. Re-insert the upper door on the middle
hinge pivot (m5) slightly tilting both
doors.
13. Re-screw the middle hinge (m2). Do
not forget the plastic spacer (m1) inser-
ted under the middle hinge. Make sure
that the edges of the doors run parallel
to the side edge of the appliance.
14. Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabi-
net.
26 electrolux
To Next Page