Electrolux ERC3505 - Troubleshooting; Troubleshooting Guide

www.electrolux.com
7
EN
ID
TH
VN
CNS
TROUBLESHOOTING
Symptoms Possible Causes Solutions
The indicator light does not
light up.
The heater plate is not
warm.
TheKEEPWARMlightdoes
not light up when the cook-
ing process is completed.
The circuit of electric rice cooker
is not connected to power supply.
Checkthattheswitch,plugand
socket,fuseandleadingwireofthe
power supply are in good condition
and properly connected to the
mains and if plug is inserted firmly
into the wall socket.
The power wiring board is dam-
aged.
Contact authorized service center.
The circuit connection breaks
down.
The master circuit board is dam-
aged.
The heater plate is burnt out.
The light is defective.
The rice is not cooked or
the cooking time is taking
too long.
Not enough water is added.
Addwatertothelevelindicatedon
the scale inside the inner pot that
corresponds to the number of cups
of rice used.
Incorrect function is selected.
Press [MENU] till desired function is
selected,thenpress[COOK]tostart
the cooking cycle.
The inner pot is not properly in
contact with the heater plate.
Make sure there is no foreign resi-
due on the heater plate.
Possible foreign matter between
the inner pot and heater plate.
The heater plate is damaged. Contact authorized service center.
The rice is too hard or too
soft.
Not enough or too much water
has been added.
Addwatertothelevelindicatedon
the scale inside the inner pot that
corresponds to the number of cups
of rice used.
The rice is scorched.
The rice has not been rinsed well. Rinse the rice until water runs clear.
The master temperature controller
is defective.
Contact authorized service center.
The rice cooker does not
automatically switch to keep
warm mode.
The master temperature controller
is defective. Contact authorized service center.
There is no timer display on
theLEDpanel.
The timer battery has run out. Contact authorized service center.