14
Electrolux 8183821-00/1
Connecting the water hose.
Remove the transport protector from the
valve connector, see the illustration.
Connect the water hose supplied with the
hose fitting to the refrigerator water valve,
which is located in a box behind the refrigerator.
Place the hose in the desired direction and then
tighten the connecting nut properly to prevent
leakage. The nut is only to be tightened by hand.
The water hose must not be cracked, squeezed
or be in tight bends. The hose is finally to be
fixed with the aid of the securing strip supplied.
The water coupling is then connected to a water
tap with an external 3/4 inch thread. This work
is to be carried out by a skilled plumbing
installation technician. The refrigerator is to be
connected with a shut-off cock. There are
different type-approved taps and tap assemblies
on the market.
If you require a longer water hose than that supplied,
then a VDE-approved 150 38 85-02/0 supply hose
should be used.
Before the refrigerator i s taken into use in its final
location, ensure that the water connection has been
correctly carried out, that there is no leakage at the
connection to the refrigerator water valve or to the
water tap, and that the four spacers are properly in
position, see t he illustration.
We recommend that the refrigerator is placed on a
"run-off" mat intended for refrigerators and freezers,
which makes it easier to detect possible leakage.
This run-off mat is available from your dealer.
Installation of carbon filter
On delivery the carbon filter is placed in a plastic
bag t o secure the length of life of the carbon filter.
The filter should be placed behind the grill before
the cabinet is turned on.
The cover can be opened by simultaneously pressing
the lever on the right of grill (1) and turning the
cover outward (2). The carbon filter is then mounted
in the slot found in the back of the cover.
The filter should be handled carefully so fragments
don't loosen from the surface.
Electrical cord
Do not remove the power cord by pulling on its
lead, particulary when the product is being
pulled out of its niche.
· Damage to the cord may cause a short-circuit, fire
and/or electric shock.
· In the event of damage to the appliance's main
cable, only an authorised service company
recommended by the manufacturer or a similarly
qualified person may adjust it in order to avoid
shock hazard for the user.
1
2
3
To Next Page
Loading...
