16
Electrolux 8183821-00/1
When the water system is started
for the first time.
The following should be carried out when the
refrigerator is correctly connected to the water
supply in the building:
Open the tap on the water connection and start up
the refrigerator. The water system main valve opens
and the system starts to fill up. Wait for five
minutes.
Unpack the filter provided and connect it as
follows:
- Insert the filter connector into the filter seat and
turn as shown in the illustration (1) until the filter
engages and the projection on the filter cartridge is
opposite the mark on the plastic cover. See also the
illustration and the instructions on the inside of the
service hatch.
- Unlock the water dispenser. See the section " The
water dispenser functions" Select carbonated water
and drain off about 1.5 litres (2.5 pints) of water.
There may be some air to start with.
Connect the gas cylinder provided as follows:
- Remove the gas cylinder protective cap and screw
the gas cylinder into t he adapter (3) for this purpose,
which is located in the valve, doing this by hand
without tools.
- Place the gas cylinder with adapter in the valve and
ensure that the valve bracket hooks are under the
counterhold on the adapter (5). Then turn up the
bracket lever (6) in one continuous movement. See
the illustration and the instructions on the inside of
the service hatch.
- Unlock the water dispenser and drain off a further
1.5 litres (2.5 pints) of water or until there are signs
that the carbonated water in the water dispenser is
startingtorun.
- The system is now ready for use. In order t o obtain
the best possible performance from the refrigerator ,
wait until the set temperature is reached. A low
temperature provides more carbon dioxide, a high
temperature less carbon dioxide.
Re-hanging the door.
It is not possible to re-hang the door. The water
supply goes through the hinge to the water dispenser.
Contact your dealer for more information.
Electrical connection
Connect the cabinet to a grounded electrical outlet.
Voltage: 230 V.
Fuse: 10 A.
Refer to the rating plate on the left inside the
cabinet.
1
2
3
4
56
To Next Page
Loading...
