1111
EN
IND
KR
TH
VIET
CH
TW
1. Place ERGORAPIDO® on a hard and even surface. Do not use the BRUSHROLLCLEAN® function on carpets.
2. Press the BRUSHROLLCLEAN® pedal with your foot while the cleaner is switched on. Hold for 5 seconds until hairs and bres are
removed and then release the pedal. There will be a cutting noise during this process, this is normal. If hairs remain on the brush
roll repeat the process. The BRUSHROLLCLEAN® function stops automatically after 30 seconds, this is for safety reasons. If this
happens please place the ERGORAPIDO® back in the charging stand to reset the function.
BRUSHROLLCEAN® Technology - Some of the
ERGORAPIDO® models are equipped with this feature.
This function helps to keep the brush roll free from
tangles and dust to maintain optimal cleaning
performances.
Please note that the BRUSHROLLCLEAN® function might
not be able to remove thicker threads, wires or bres
that are caught in the brush roll.
APAC_ErgoIFU_BED_Master.indd 11 2016-05-31 11:09:45
To Next Page
Loading...
