99
EN
IND
KR
TH
VIET
CH
TW
On ERGORAPIDO® the numbers of LED lamps will indicate the level of charge.
3 LED = fully charged. If ERGORAPIDO® is fully discharged, it requires
approximately 4h. For better battery performance, always keep ERGORAPIDO®
on charge when it is not being used.
The Bed Pro Power nozzle is designed to remove dust
and allergens from your bedding and mattress. Connect
the nozzle to the inlet at the hand unit. To remove it, press
the lock button and pull the nozzle o. Keep the inlet
connection tube clean from dust or dirt to make it easier to
remove and assemble towards the vacuum cleaner.
A
UV light function. Press the On/O button to start the hand unit and the Bed Pro Power
nozzle. Press the UV active button “A” and place the nozzle towards the bed or mattress to
activate the UV light. A blue LED light will illuminate to indicate that the UV light is active.
For safety reasons, the sensors will turn o the UV light if the nozzle is lifted from the
surface. If you want to clean without UV light, you can turn it o by pressing the UV active
button again.
Note: The UV light may not always activate when the nozzle is used on some darker
colored or patterned bed sheets.
APAC_ErgoIFU_BED_Master.indd 9 2016-05-31 11:09:42
To Next Page
Loading...
Need help?
General
