Fault code and malfunction Possible cause and solution
The programme does not start • The appliance door is not closed.
Close the door.
• Mains plug is not connected in.
Put in the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start is set.
Cancel the delay start to start the programme immediately.
After the check, switch on the appliance.
The programme continues from the point of
interruption. If the malfunction shows again,
contact your Service Force Centre.
For other fault codes, not described in the
chart, contact your Service Force Centre.
These data are necessary to help you
quickly and correctly:
• Model (Mod.)
• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........
The cleaning results are not satisfactory
The dishes are not clean • The selected washing programme is not applicable for the type of
load and soil.
• The basket is loaded incorrectly so that water cannot reach all
surfaces.
• Spray arm does not turn freely because of incorrect arrangement
of the load.
• The filters are dirty or not correctly installed.
• The quantity of detergent is too little or missing.
Limescales particles on the
dishes
• The salt container is empty.
• The water softener is adjusted on a wrong level.
• The salt container cap is not closed correctly.
The dishes are wet and dull • No rinse aid has been used.
• The rinse aid dispenser is empty.
There are streaks, milky
spots or a bluish coating on
glasses and dishes
• Decrease the rinse aid dosage.
Dry water drop signs on
glasses and dishes
• Increase rinse aid dosage.
• The detergent can be the cause.
TECHNICAL DATA
Dimensions Width
Height
Depth
54,5 cm
44,7 cm
48,0-49,0 cm
Electrical connection - Voltage -
Overall power - Fuse
Data on the electrical connection are on the rating plate on the
back of appliance.
Water supply pressure Minimum
Maximum
0,8 bar (0,08 MPa)
10 bar (1,0 MPa)
Capacity 6 place settings
electrolux 13
To Next Page
Loading...
