INSTALLATION
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Fitting the appliance
Put the appliance adjacent to a water tap
and a drain.
When you put the appliance in place, make
sure that the water hoses are not kinked or
squashed.
Install the appliance on a kitchen sink,
worktop or built-in..
Positioning
Install the dishwasher into the furniture of
the kitchen.
Make sure that the dimensions of the re-
cess agree with the given dimensions.
Make sure that there are openings in the
furniture for the inlet hose, the water drain
hose and the mains cable.
Adjusting the level of the appliance
Make sure that the appliance is level to
close and seal the door correctly. If the level
of the appliance is correct, the door does
not catch on the sides of the cabinet. If the
door does not close correctly, loosen or
tighten the adjustable feet until the appli-
ance is level.
WATER CONNECTION
Inlet hose
The appliance has safety features to pre-
vent that the water in the appliance goes
back into the drinking water system.
Connect the appliance to a hot (max. 60°)
or cold water supply.
If the hot water comes from alternative
sources of energy that are more environ-
mentally friendly (e.g. solar or photovoltaic
panels and aeolian), use a hot water supply
to decrease energy consumption.
It is important that a water tap or stopcock
is near the dishwasher with easy access.
Connect the inlet hose to a water tap with
an external thread of 3/4”. If it is necessary,
use the restrictor 1/2".
14 electrolux
To Next Page
Loading...
