Electrolux ESF6767KXA - Page 26

26 electrolux.com.au
Iftheprogramwon’tstart
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine door.
• Be sure that you switched o the machine by
pressing the Power On / O button.
• Be sure that the water inlet lter and the machine
lters are not clogged.
Ifdetergentresiduesareleftinthedetergent
compartment
• Detergent has been added when the detergent
compartment was wet.
Ifwaterisleftinsidethemachineattheendof
theprogram
• The water drain hose is clogged or twisted.
• The lters are clogged.
• The program is not nished yet.
Ifthemachinestopsduringawashoperation
• Power failure.
• Water inlet failure.
• Program can be on standby mode.
Ifshakingandhittingnoisesareheardduringa
washoperation
• Dishes placed incorrectly.
• Spray arm hitting the dishes.
Iftherearepartialfoodwastesleftonthedishes
• Dishes placed incorrectly into the machine, sprayed
water did not reach related places.
• Basket overly loaded.
• Dishes leaning against one another.
• Very small amount of detergent added.
• An unsuitable, rather weak wash program selected.
• Spray arm clogged with food wastes.
• Filters clogged.
• Filters incorrectly tted.
• Water drain pump clogged.
Iftherearewhitishstainsonthedishes
• A very small amount of detergent is being used.
• Rinse aid dosage setting at a very low level.
• A detergent without phosphate used; try one that
contains phosphate.
Ifthedishesarenotdry
• A program without a dry operation selected.
• Rinse aid dosage set too low
• Dishes unloaded too soon
Ifthereareruststainsonthedishes
• Stainless-steel quality of the dishes washed is not
dishwasher grade.
• High level of salt in the wash water.
• Poor mains grounding.
Call an Authorised Service Centre if the problem still
persists after the controls or in case of any malfunction
not described above.
TROUBLESHOOTING (CONTINUED)