Electrolux ESF6767KXA - Page 27

27
Errorcode Possiblecauseandsolution Control
F1
Overll
• Power o your machine and close the tap.
• Contact the customers services centre.
F2
Not draining
• Water discharge hose is clogged.
• Water drainage hose kinked, check installation.
• The lters of your machine might be clogged.
• Power o–on your machine and activate the program
cancellation command.
• If the error continues, contact the Customer Care Centre.
F3
Inlet valve faulty
• Close the tap.
• Contact the Customer Care Centre.
F5
Inadequate water supply
• Make sure the water tap is fully open and that there is
mains water available.
• Water inlet hose kinked, check installation.
• Close the water tap, disconnect the hose from the tap
and clean the lter at the connection.
• Restart your machine, contact the service if the error
resumes.
F6
Faulty heater sensor
• Contact the Customer Care Centre.
F7
Over temperature
• Contact the Customer Care Centre.
F8
Heating error
• Contact the Customer Care Centre.
F9
Diverter valve faulty
• Contact the Customer Care Centre.
FE
Power supply problem
• Contact the Customer Care Centre.
Errorcodes,causeandsolution