1
2
3
• Unscrew the lower hinge (1). Move the
pin to the opposite side (2).
• Unscrew and move the pedal to the op-
posite side (3).
2
1
• Unscrew (1) and move (2) the bracket to
the other side on the door.
• Screw on the lower hinge on the oppo-
site side.
• Tighten the pin with the adjustment
spanner supplied.
• Raise the appliance and install the venti-
lation grill.
• Remove the covers on the handles care-
fully with a small screwdriver.
• Unscrew the handle.
• On the opposite side remove the hole
covers by driving a 3–4 mm drift or drill
into them.
• Install the handle.
• Install the covers on the handle.
• Install the hole covers provided within the
accessory bag.
• Put the cabinet in position.
WARNING!
Reposition, level the appliance,
wait for at least four hours and then
connect it to the power socket.
Do a final check to make sure that:
•All screws are tightened.
• The magnetic seal adheres to the cabi-
net.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natu-
ral fitting of the gasket.
8. NOISES
There are some sounds during normal run-
ning (compressor, refrigerant circulation).
ENGLISH 15
To Next Page
Loading...
