54 maintenance and cleaning
Removing the trays and shelves from the appliance
1. Slide the dish and shelves towards you until they reach
the front stop.
2. Tilt them up at the front to clear the side supports,
taking care not to spill the contents.
3. Lift them clear.
4. Wash the dish and insert the shelves in hot soapy
water.
5. Reverse the above steps to put the grill dish and
shelves back again.
6. Ensure that they are placed between two support
wires.
7. To remove a tray from a sliding position:
– Pull tray towards you until it stops.
– Lift the tray clear.
Removing the side racks
1. Grasp the middle wire at the front.
2. Pull firmly inwards.
WARNING!
Make sure the appliance is turned off before you
remove or replace parts, to avoid the possibility of
electric shock.
CLEANING THE ACCESSORIES
Removing and replacing the oven back light and
side light (if fitted)
• Turn oven light glass anticlockwise to remove it for
globe replacement.
• To remove side light, place a spoon under the light
glass and lever off. Replace globe and snap glass
cover back into position.
• A special high temperature resistant globe should
be used. This can be purchased from Electrolux
Customer Care Centre.
Releasing the grill element
To clean the oven roof rotate latch until the element drops
down freely .
To Next Page
Loading...
Need help?
General
