6 electrolux.com.au
Levelling oven
Place a level in the oven as below making sure the level sits
on the front and rear forms. The level needs to be correct
to prevent slides from moving in or out with gravity.
✓
Underbench oven
Your underbench oven looks best when the control panel
is directly under the benchtop. An upper infill panel may
be added if the cooktop placed above the benchtop is too
deep. Refer to cooktop installation instructions for required
clearance between cooktop and oven.
IMPORTANT!
Note: Dimension ‘D’*
A requirement for all EVEPxxxx pyrolytic clean
ovens and all Duo ovens – for proper ventilation
there MUST be a gap at the bottom rear of the
cabinet. This can be a full width opening 20mm
deep. Refer to dimension “D” in relevant diagram.
Power point connection for the EVEP618/619 must be
accessible with the appliance fully installed. If the supply
cord is damaged it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to
avoid a hazard.
Cut-out dimensions
type of fit A (width) B (height) C (depth)
Flush fit (mm) 600 600 581 min.
Proud fit (mm) 568 590 560 min.
561mm
mounting
holes
582mm.
Fit black
screws
provided.
596mm
Double oven Cut-out dimensions
type of fit A (width) B (height) C (depth)
Flush fit (mm) 600 1086 581 min.
Proud fit (mm) 568 1078 560 min.
561mm
recommended
450mm min.
mounting
holes
582mm.
Fit black
screws
provided
mounting holes.
Fit black screws
with plastic
spacers provided
Pyrolytic underbench Cut-out dimensions
type of fit A (width) B (height) C (depth) D*
Flush fit (mm) 600 600 581 min. 20
Proud fit (mm) 565 590 560 min. 20
mounting
holes
582mm. Fit
black screws
provided
561mm
596mm
Duo oven Cut-out dimensions
type of fit A (width) B (height) C (depth) D*
Flush fit (mm) 600 893 581 min. 20
Proud fit (mm) 565 885 560 min. 20
561mm
mounting
holes 582mm.
Fit black
screws
provided
mounting holes. Fit
black screws with plastic
spacers provided
recommended
450mm min.
IMPORTANT INSTRUCTIONS (CONTINUED)
To Next Page
