Problem Possible solution
The display shows Err. If you want to set a new programme, de‐
activate and activate the appliance.
Make sure that the options are applicable
to the programme.
The display shows (e.g. E51). Deactivate and activate the appliance.
Start a new programme. If the problem
occurs again, contact the Service.
1)
After maximum 5 hours, the programme ends automatically.
2)
It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not
satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the
appliance.
• The drum is dirty.
• Incorrect setting of the conductivity
sensor ( See chapter "
Settings -
Adjustment of the remaining laundry
moisture degree
" for better setting).
• The airflow slots are clogged.
• Room temperature is too low or too
high ( optimal room temperature 19°C
to 24°C )
13. TECHNICAL DATA
Height x Width x Depth 850 x 596 x 570 mm (maximal 594 mm)
Max. depth with the appliance door open 1039 mm
Max. width with the appliance door open 958 mm
Adjustable height 850 mm (+ 15 mm - feet regulation)
Drum volume 104 l
Maximum load volume 7 kg
Voltage 230 V
Frequency 50 Hz
Sound power level 66 dB
Total power 2800 W
Energy efficiency class B
Energy consumption on the standard cot‐
ton programme with the full load.
1)
4,23 kWh
Energy consumption on the standard cot‐
ton programme with the partial load.
2)
2,29 kWh
ENGLISH 17
To Next Page
Loading...
