EasyManua.ls Logo

Electrolux EW6F348SA - Hints and Tips

Electrolux EW6F348SA
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the On/Off button for a few
seconds to deactivate the appliance.
10.12 Stand-by function
The Stand-by function automatically
deactivates the appliance to reduce the
energy consumption when:
You do not use the appliance for 5
minutes when no programme is
running.
Press the button On/Off to activate
the appliance again.
5 minutes after the end of the washing
programme.
Press the On/Off button to activate
the appliance again.
The display shows the end of the last
programme.
Turn the programme dial to set a new
cycle.
If the dial is rotated to the "Reset"
position , the appliance automatically
turns off in 30 seconds.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
The remote control inhibits
the Stand-by option, but
after 15 minutes the
appliance enters in Network
Stand-by mode and the
display shows the indicator
only.
11. HINTS AND TIPS
WARNING!
Refer to Safety chapters.
11.1 The laundry load
Divide the laundry into: white,
coloured, synthetics, delicates and
wool.
Follow the washing instructions on the
laundry care labels.
Do not wash white and coloured items
together.
Some coloured items can discolour
with the first wash. We recommend
that you wash them separately for the
first couple of times.
Turn multilayered fabrics, wool and
items with printed illustrations inside
out.
Pre-treat tough stains.
Wash heavy soil stains with a special
detergent.
Be careful with curtains. Remove the
hooks and put the curtains in a
washing bag or pillowcase.
Do not wash laundry without hems or
with cuts. Use a washing bag to wash
small and/or delicate items (e.g.
underwired bras, belts, tights,
shoelaces, ribbons, etc. ).
A very small load can cause balance
problems with the spin phase leading
to excessive vibration. If this occurs:
a. interrupt the programme and
open the door (refer to "Daily
Use" chapter);
b. manually redistribute the load so
that the items are spaced evenly
around the tub;
c. press the Start/Pause button.
The spin phase continues.
Button up pillowcases, close zippers,
hooks and poppers. Tie up belts,
cords, shoelaces, ribbons and any
other loose elements.
Empty pockets and unfold the items.
ENGLISH 35

Related product manuals