18.11 Cleaning the inlet hose filter and the valve filter
It could be necessary to clean the filters when:
• The appliance does not fill with water.
• The appliance takes long time to fills with water.
• The indicator of the Start/Pause button flashes and the display shows the related alarm.
Refer to 'Troubleshooting' chapter.
To clean the water inlet filters:
• Close the water tap.
• Remove the water inlet hose from the
water tap.
• Clean the filter in the inlet hose with a stiff
brush.
• Remove the inlet hose behind the
appliance.
• Clean the filter in the valve with a stiff
brush or a towel.
• Install again the inlet hose. Make sure that
the couplings are tight to prevent
leakages.
• Open the water tap.
ENGLISH 47
To Next Page
Loading...
