3.4 Water inlet
WARNING!
This appliance must be
connected to a cold water
supply.
Before connecting up the
machine to new pipework
or to pipework that has not
been used for some time,
run off a reasonable
amount of water to flush
out any debris that may
have collected in the
pipes.
1. Connect the water inlet hose
supplied with the machine to a tap
with a 3/4" thread. Always use the
hose supplied with the appliance.
Do not use the hose
from your previous
machine to connect to
the water supply.
2. The machine end of the inlet hose
can be turned in any direction. Set
the hose correctly by loosening the
ring nut. After positioning the inlet
hose, be sure to tighten the ring nut
again to prevent leaks.
3.5 Water drainage
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink using
the plastic hose guide supplied with
the machine.
In this case, make sure the end cannot
come unhooked when the machine is
emptying. This could be done by tying it
to the tap with a piece of string or
attaching it to the wall.
In a sink drain pipe with a trap.
The drain hose can be connected directly
into the pipe (e.g. beneath a washtub or
sink), above the water trap. The drain
hose must be arranged so that some part
of it’s length is routed up to a level
corresponding to the top edge of the tub
and fixed in place there.
Directly into a drain pipe at a height of
not less than 65 cm and not more than
80 cm.
www.electrolux.com8
To Next Page
Loading...
